Getting started
In order to use the RE·BL with a PS3, an IR remote is needed. The RE·BL defaults to using the original PS2 IR codes, any IR remote that can transmit these codes can be used. This quick start guide will focus on configuring a Logitech Harmony Remote for use with the RE·BL.
Configure IR remote (Logitech Harmony)
From the Logitech Harmony software select the Devices tab and then Add device. Select Game Console > Game Console (With DVD) from the device selection box, WB Electronics from the manufacturer selection box and enter the name ”REBL” in the model name. Finish by pressing next and next. For information on how to add the RE·BL device to Activities in the Harmony Remote, see the Harmony manual.
Logitech Harmony selection:
Device: Game Console > Game Console (With DVD)
Manufacturer: WB Electronics
Model: REBL Power on and pairing the RE·BL with a PS3
Make sure the RE·BL is completely turned off, if batteries are used remove these also (See manual on how to remove or replace batteries).
Turn on your PS3 system and use your PS3 controller to select the following option:
Settings > Accessory Settings > Register BD Remote
Firmware 1.23 (Software 1.19) or higher:
Power on the RE·BL by inserting either batteries, DC adaptor or USB power. When power is applied, the red LED will start flashing to indicate that the RE·BL is entering auto-pairing mode. Do not press any key, RE·BL and the PS3 will automatically pair, and the screen changes to Registering within a few seconds.
Older firmware:
Power on the RE·BL by inserting either batteries, DC adaptor or USB power. When power is applied, the red LED will start flashing to indicate that the RE·BL is ready to be paired. Within the first 20 seconds, press and hold the ‘2’ button on the remote until the PS3 changes screen to Registering.
Now the RE·BL is paired with the PS3 and ready for use! |
